![]() ![]() This is where you put the standalone GRUB package after the installation. When asked to partition your hard drive, create a small HFS partition. Note: Refer to the Mac page if you do not want to have a separate partition for GRUB but rather prefer to use rEFInd. Select the live USB with the arrow keys, and press Enter to boot into the live Arch Linux environment.Ĭopy the entire folder with the firmware for your wireless card to /usr/lib/firmware/. After a few seconds, you should see Apple's boot loader display the choice of either starting up the built-in drive with OS X or the USB drive you plugged in. Hold the option key, then press the power button. ![]() In the end, you should have a folder named b43 with a lot of. You can just copy it from another b43-enabled Arch, extract it from Broadcom's driver using b43-fwcutter, or get the firmware through the b43-firmware AUR package. In order for the Wi-Fi chipset to work, you need to get the firmware for it. You can either create your Linux partition directly here, or do that later in Linux during the installation (using parted and mkfs). The general installation guidelines are described in Mac.Īssuming you want to dual boot with OS X, you have to shrink its partition with the Disk Utility. This page applies to the MacBook Pro 10,1 with Retina display. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |